| F1 = CQ |
Shift+F1 = Call CQ and switch to run |
| ; or insert = Send call and report |
Alt+U= Toggle S&P/Run. Set CQ-frequency for pass |
| ' = Send TU message and enter in log |
Alt+Q = Return to CQ-frequency |
| Alt+R = Enable CQ repeat |
Ctrl+Up/Dn arrow = Grab next qso from bandmap |
| Ctrl+R = Set repeat time |
Ctrl+Alt+Up/Dn arrow = Grab next mult from bandmap |
| Esc = Stop sending, stop repeat |
- |
General keys |
Radio control |
| Ctrl+O = Set operator call (or OPON in Callsign field) |
Alt+F10 = Swap VFOs |
| Ctrl+N = Add note to log |
Alt+Q = Return to CQ frequency |
| Ctrl+W or Alt+W = Wipe entry fields, Release a reserved serial number |
Alt+F8 = Return to last frequency |
| SPACE or TAB = Move between logging fields |
Ctrl+PgUp/PgDn = Up/Down a band |
| ENTER = Log it (see ESM mode) |
Type CW/USB/LSB/RTTY = Change mode Type frequency in KHz = Change frequency or band |
| Ctrl+Q/A = Quick edit previous or next call |
Ctrl+S = Set radio into split Ctrl+Alt+S - Toggle split mode |
| Ctrl+D = Delete last qso! |
Ctrl+Enter = Set split frequency |
| Alt+H = Show help |
Alt+F7 = Set split frequency or offset to specified frequency |
| Alt+K = Edit message buttons |
Alt+' = Toggle between the wide and narrow filters |
| Ctrl+Alt+Enter = Log a not accepted 'invalid' qso |
Alt+F12 - Copy frequency and mode to other radio/VFO or swaps MAIN and SUB using the CAT radio command |
| - |
Backslash ( \ ) = Change Receive (RX) focus (VFO/Radio) |
DX Spots and Band Map |
ESM Mode |
| Mouse wheel = Zoom in/out bandmap |
Ctrl+M = Turn on/off |
| Keypad +/- = Zoom in/out bandmap |
Insert or ; = Send call and exchange |
| Alt+D = Remove spot |
Enter = Send TU and log it |
| Alt+P = Send spot |
Enter = Start CQ again... |
| Ctrl+P = Send spot with comment |
Alt+Enter = Log without sending anything |
| Ctrl+Tab = Toggle to/from packet window |
Multi-User Mode |
| Alt+O = Store contact in the Bandmap |
Alt+Z = Set pass frequency (broadcast to all computers) |
| Alt+Q = Jumps to the CQ frequency on this band |
- |
SO2R |
Specific radios / Rotor control |
| Backslash ( \ ) - Two radios = Change Receive (RX) focus |
FT-1000MP + FT1000D + some Icom Dual Watch radios Alt+F12= Dual Receive toggle |
| Pause = Swap both Transmit and Receive/Keyboard focus |
|
| Ctrl+Enter = Send next ESM state on alternate radio |
TenTec Orion Alt+F12 = Toggle Main/left Sub/Right and Active in both ears. |
| Ctrl+F1 to F12 = Send message on alternate radio |
|
| Ctrl+B = Dueling CQ's |
Rotor control for the callsign in the Entry window |
| ` (Back-quote) = Toggle Stereo/Mono ( LPT pin 5) |
Alt+J - Turn rotor to bearing |
| Ctrl+I - Toggle through sound card SO2R supported modes ($5SO2R) |
Alt+L - Turn rotor to long path bearing |
| - |
Ctrl+Alt+J - Stop turning the rotor |
